Resetting your router might assist if you're having problems with your network, poor internet, or inability to access your router dashboard. You may start again with a new configuration by restoring your Orbi device to factory settings. We'll show you how to reset Orbi router step-by-step in this article.

How Often Should Your Orbi Router Be Reset?

If you are unable to access orbilogin.com because you have forgotten your admin password,

• When your internet slows down or keeps disconnecting

• If the Orbi router configuration isn't functioning properly

• After updating your system or switching network providers

Procedure for Orbi Router Resetting

Find the button labeled Reset.

• There is a little reset button on the rear of your Orbi satellite or router.

• Usually, it's within a pinhole.

Press and Hold

• Press and hold the reset button with a paperclip or pin for ten to fifteen seconds, or until the power LED begins to flicker amber.

Wait for Reboot

• Once the router reboots, it will be restored to factory settings. This means all custom settings like WiFi name (SSID) and password will be erased.

Reconfigure Your Router

• After resetting, you’ll need to perform orbi router setup again. To do this, connect your device to the Orbi network, open a browser, and go to orbilogin.com. Follow the on-screen steps to configure your network, set up WiFi credentials, and customize your admin settings.

Advice for a Stress-Free Reset

• If at all feasible, always make a backup of key settings.

• Before trying a reset, make sure your Orbi device is turned on.

• After setup is finished, try upgrading the firmware on your router using orbilogin.com if resetting doesn't fix the problem.

You can rapidly reset your Orbi router and have it operating at its best by following these instructions. A factory reset gives your home WiFi network a new start and is frequently the most dependable solution for ongoing connectivity problems.

To get further details visit our webpage.